  
Single Roll Lab Coater,
Manual Unit: Model#E-BC12M1
Single Roll Lab Coater,
110 Volt Power Unit:
Model#E-BC12P1
Single Roll Lab Coater,
220 Volt Power Unit:
Model#E-BC12P1 |
Contact
Euclid Coating Systems
for a Quotation |
|
Optional: Precision Air Regulator and Air Gauge for
extreme accuracy and precise control of pneumatic wiper blade for
controlling final coating weight.
-
Excellent for doing drawdowns and performing
tests onto small samples and hand sheets.
-
Applies a uniform, consistent, and repeatable
coating laydown every time.
-
Primarily used for applying thin coatings
onto papers and films.
-
Applies coatings from as low as 1/10 of 1
micron (.000004”) to as high as 5 mils (.005”).
-
Coat weight is controlled by varying the air
pressure of the patented pneumatic wiper blade which presses against the
back of the rubber roll (requires compressed air of at least 60 p.s.i.
supplied by customer).
-
Features a 6” diameter x 12” wide standard neoprene
rubber roll, and mounts between aluminum side frames.
-
Different types of
rubber coverings for the roll including E.P.D.M., Silicone, Viton, Hypalon,
Buna-N, Urethane, Polysulfide, and Natural Rubber are also available
(prices vary).
-
Manual unit contains a
handle for rotating the roll.
-
Power unit contains a
variable speed motor and controller for rotating the roll, available in
110 or 220 Volts.
-
Delivery time: 3 -
4 weeks
Instructions for use:
Simply attach one end of the substrate to the surface width
of the roll by using a piece of tape, apply desired air pressure to the
wiper blade, pour the coating mixture down between where the blade edge
touches against the roll, turn the roll one revolution, and remove the
coated substrate.
3494 N. Euclid Ave.
Bay City, MI 48706 U.S.A.
|
|
|
|
|
|
